ssembling tanks can be a bit tricky the first time out. There are just so many parts! The printed diagrams included with every tank kit show what needs to be done pretty clearly, but sometimes a little bit of good ol' photography can go a long way. With this in mind, we've compiled a complete step-by-step guide for assembling your tanks. Have the instructions which came with your tank handy as you move through the steps. With both of these resources, you're sure to build your tank correctly and without any mishap. One important thing to keep in mind as you work is to dry fit all the pieces before committing with glue. This way, you can correct any parts that don't line up or fit. Note: The Demolisher and Leman Russ are very similar in assembly. This guide will build both tanks and points out any differences between the two.
 |
 |
 |
Clip off 12 small wheels, the medium wheel, and the large wheel for each hull side. |
Glue the wheels in place as shown, with the bolts facing up. |
Add a drop of glue to the top of each wheel before moving on. |
 |
 |
 |
Line up the pegs with the other half of the hull side. |
You'll hear the hull side snap into place. Press firmly. |
Press the other end until it snaps into place as well. |
 |
 |
 |
Add a single small door (B5, B6) if you plan on adding sponsons. If not glue both doors in place. |
You should now have two hull sides ready for the tracks. |
Clip out a long tread, two "8" treads, two "4" treads, a "2" tread, and five individual treads. |
 |
 |
 |
Line up an "8" tread so that it meets up with this rear rivet like so. |
Glue a "4" tread into place towards the front of the tank. |
Add a pair of individual tracks. |
